The Moser Engineering Complete Junior Dragster Assembly has again set the standard when it comes to safety by proudly announcing the finest Junior Dragster Assembly available in the market today. Our Made in the USA JR Dragster Axle Assemblies are manufactured in house from the highest quality 7075-T6 Aircraft Grade Aluminum and then hard anodized for years of trouble free use. The axle shaft is made from the same Aircraft Quality Material and utilizes a 35 spline shaft for safety to connect the Moser Sprocket Hub. The axle then connects to a standardized 28 spline Moser hub. Then we add Free Spinning Performance Bearings and a Drilled 7" Steel Rotor for the added advantage that not only gets you across the line first but also safely back to the pits. (will not work with a hardtail)



Moser Engineering brings out the kid in you, but delivers the safety a father demands!



The Product shown is represents 18" Axle Flange to Axle Flange. Other lengths can be manufactured at your request in a reasonable time frame.